Taprite Co2 permanant O-ring for Nipple
Taprite Co2 permanant O-ring for Nipple
Taprite Co2 permanant O-ring for Nipple
Taprite Co2 permanant O-ring for Nipple
Roll over image to zoom in Click on image to zoom
Taprite Co2 permanant O-ring for Nipple
Taprite Co2 permanant O-ring for Nipple
Taprite Co2 permanant O-ring for Nipple
Taprite Co2 permanant O-ring for Nipple

Taprite Co2 permanant O-ring for Nipple

Item Number: c384-44017R
Price:
$1.99
Stock:
In stockEligible for Fast & Free Delivery

Description

Replacement washer fits between a Taprite regulator and the CO2 cylinder. Reusable.

Over time, Taprite CO2 regulator fittings can become worn at the seals and cause harmful CO2 leaks in your setup. This flat seal is used to repair and replace those old, worn seals and restore your beer-dispensing system to its prime.

Simply use a 5/32” Allen wrench to remove the brass plug at the end of the stem, remove the old flat seal, replace with this new one, and then reinstall the plug.

Dimensions are:

3/32" thick
7/16" ID
5/8" OD

Payment & Security

American Express Apple Pay Diners Club Discover Meta Pay Google Pay Mastercard PayPal Shop Pay Venmo Visa

Your payment information is processed securely. We do not store credit card details nor have access to your credit card information.

Customer Reviews

Based on 7 reviews
100%
(7)
0%
(0)
0%
(0)
0%
(0)
0%
(0)
R
Robert Kirkwood
Works great

These seemed to be out of stock everywhere for a while so I was down to only one CO2 tank. Found them here, easy install, no leaks anymore. Thank you!

R
Richard Cleveland
Perfect

After losing my second tank of co2 due to a very slow leak at the tank coupler I went searching for the proper o-ring for my Taprite regulator Assm. Note each brand uses a different type o-ring. This was the correct ring for the Taprite brand!

B
Brian English
Works perfectly

Exactly what it says it is. Works great. No leaks!

S
Steve
Fixed seal

Fixed my seal issue for my traveling CO2 regulator.

R
Ronald Moody
Bit touchy

This will work with the Taprite CO2 stem, it just takes some tinkering to get it to fit. First step is to remove the center retainer with a hex wrench. Remove the old seal and press the new one in as best you can. It probably will not seat well at all at this point. Next, put the retainer back on and tighten with the hex wrench, then remove it again, then re-tighten. This seated the seal for me. I tested and it's holding pressure like it should.

12

You may also like

Recently viewed