Description
This kit includes a stainless steel sight gauge and 6 inch thermometer.
Sight Gauge Stainless Steel Tee Assembly
These are very easy to install in to a 1/2" NPT coupling already installed in your kettle and will come with a full set of instructions. These sight gauges will fit most kettles up to 15 gallons. They are approximately 18" from the top of your 1/2" coupling.
This sight gauge is perfect if you only have one fitting and want to add a sight gauge where your ball valve is. You simply remove your ball valve and install this sight gauge assembly and put your ball valve in to the tee and you're all set.
You can also use this when you want to put a sight gauge where your thermometer is already installed. Simply uninstall the thermometer and install this into that coupling and re-install your thermometer into this assembly.
1- Set of Vinyl Graduation Stickers (2-15)
Optional Eye bolt allows you to attach the sight tube to your kettle, all you will need is a 1/4" drill bit and drill to do this. It is not always necessary to do this depending on how straight your coupling is welded to the kettle. We only offer a 4" eye bolt for this sight gauge because it will be considerably further away from the kettle than our other sight gauges, this may not be long enough depending on if your coupling is welded straight or not. You may want to wait until you install this and get a good measurement before you buy one. These should be available at your local hardware store as well.
Cleaning Your Sight Tube:
A simple occasional light cleaning with your favorite cleaner and a 3/8" nylon hose brush is all you need to do.
If you are doing deep cleaning of more than 30 minutes, it is recommended to remove the sight gauge and install a hole plug during this cleaning period because extended contact of cleaning detergents could cause the poly-carbonate to crack.
Avoid direct flame contact and use a heat shield if necessary to avoid excessive heat to your sight gauge; the poly-carbonate tubing has a rating of up to 250 degrees. Paying attention to avoid both of these will increase the life of your sight gauge for many brews!
calibration screw. Perfect for brewers who have a brew pot/mash tun with
a 1/2" female NPT coupling already installed. Deep enough for an
accurate reading near the center of your mash.
Payment & Security
Your payment information is processed securely. We do not store credit card details nor have access to your credit card information.